formulas of centrifugal pump|centrifugal pump coverage chart : white label Specific Speed of pump (Nq) is identifies the geometrical similarity of pumps. It is useful to comparing different pump designs irrespective of pump size 1. 1.1. Nq = Dimensionless … See more BZ mud gas separator can remove the large amount of gas cut, avoid the occurrence of well kick or blowouts, effectively prevent the erosion of harmful gas such as H2S, ensure the safety of operation and equipment different models for your choice. Welcome to BZ Solids Control !
{plog:ftitle_list}
$5.48
Centrifugal pumps are widely used in various industries for the transportation of fluids. Understanding the key formulas associated with centrifugal pumps is essential for designing and operating these pumps effectively. In this article, we will explore important formulas related to centrifugal pumps, including the calculation of fluid volume, velocity, Reynolds number, and more.
Volume of the fluid (Q ) Velocity of the Fluid ( V ) Here V = Velocity of fluid in m/sec Q =Volume of Fluid (m3/sec) A = Pipe line area (m2) V = Velocity of fluid in m/sec Q =Volume of Fluid in m3/hr A = Pipe line dia in mm ReynoldsNumberof the fluid HereD = Dia of the tube in meters V = fluid velocity in m/sec ρ=density
Volume of the Fluid (Q)
The volume of fluid flowing through a centrifugal pump can be calculated using the formula:
\[ Q = A \times V \]
Where:
- \( Q \) = Volume of fluid (m³/sec)
- \( A \) = Pipe line area (m²)
- \( V \) = Velocity of fluid in m/sec
Velocity of the Fluid (V)
The velocity of the fluid in a centrifugal pump can be determined by the formula:
\[ V = \frac{Q}{A} \]
Where:
- \( V \) = Velocity of fluid in m/sec
- \( Q \) = Volume of fluid in m³/hr
- \( A \) = Pipe line diameter in mm
Reynolds Number of the Fluid
The Reynolds number of the fluid flowing through a centrifugal pump can be calculated using the formula:
\[ Re = \frac{D \times V \times \rho}{\mu} \]
Where:
- \( Re \) = Reynolds number
- \( D \) = Diameter of the tube in meters
- \( V \) = Fluid velocity in m/sec
- \( \rho \) = Density of the fluid
- \( \mu \) = Viscosity of the fluid
Hydraulic Pump Power The ideal hydraulic power to drive a pump depends on liquid density , differential height to lift the material and flow rate of the material. Here 1. Hydraulic power in
In general, the liquid and gas separator is installed on the side ground of the mud tank.The ground shall be horizontal, solid and equipped with anchor bolt pit. When installation, use crane to lift the lifting lug on the top of the main body to lift vertically with the ground, slowly put it down, and then use steel wire rope from the upper part of the main body and the ground to take up, to .
formulas of centrifugal pump|centrifugal pump coverage chart